00050048.DOC, Version 1.1
19/35
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the spot to the mains, the EUROLITE LED PST-Scan 3W DMX 6000K 6° starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, UP and DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.
- Stand Alone mode
* Setting Scanning Speed
* Internal Programs
* Sound Control
- DMX-mode
Control Board
The Control Board offers several features: you can run the internal programs or set the starting address.
Browse through the main menu by pressing MODE. You can change the selection by pressing UP or DOWN.
The functions provided are described in the following sections.
Stand Alone mode
Setting scanning speed
Press the MODE button to select the scanning speed mode. When the display shows SP-, you can select
the desired speed via the UP or DOWN buttons.
Mode:
Value:
Function:
SP
SP 1 ~ 5
Fast ~ slow
Setting internal programs
Press the MODE button to select the internal programs mode. When the display shows P-, you can select
the desired internal program via the UP or DOWN buttons.
Mode:
Value:
Function: Scanning Angle
P1
90°
P2
180°
P3
270°
P4
360°
P
P5
540°
