00027825.DOC, Version 1.3
22/28
DMX OUT
DMX IN
LIGHT 12
LIGHT 11
LIGHT 9
LIGHT 7
LIGHT 5
LIGHT 3
LIGHT 1
FUSE: F 4 A/230 V
POWER IN
AC 100-240 V 50/60 Hz
ON
OFF
LIGHT 10
LIGHT 8
LIGHT 6
LIGHT 4
LIGHT 2
100-240 V AC, 50/60 Hz ~
Connection with luminaries
Connect your loads to the 4-pin connection cables at the load outputs of the controller.
Connect the controller to the mains with the power plug. With the POWER switch, you can switch the
controller on and off.
Attention:
The maximum length of the connection cable between load and controller may not exceed 50 m.
Outputs
The output sockets are located on the rear panel. Connect your loads to the connectors. The maximum load
per channel is 27 W. Please note that the maximum current must never be exceeded!
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the side panel of the EUROLITE LED PSI-1 DMX you can find an XLR jack (DMX Out) and an XLR plug
(DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
