______________________________________________________________________________________________
______________________________________________________________________________________________
www.eurolite.de
20
5
5
5
5....
Mounting and Connection
1
Fix the LED strip at a desired place by means of the self-adhesive foil
on the rear side. The installation place should be clean, dry and free
of grease.
2
Connect the plug of the control unit via the link connector to the
connection rail at one end of the LED strip. The arrows and the
lettering of both components must match. Otherwise the LEDs do not
light up.
3
Fix the control unit at a suitable place with two screws or fix it with the
self-adhesive foil on the rear side.
4
Fix the infrared sensor with adhesive tape so that it is capable of
receiving the control signals from the remote control without obstacles.
5
Connect the supplied power supply unit to power input at the control
unit and to a mains outlet. The power supply unit’s LED lights up.
Interconnecting Two LED Strips
The power supply unit included is able to power up to 10 meter of the LED
strip, i.e. 2 LED strips can be interconnected. For this, connect the ends of
both strips with the included link connector. Again, observe the correct
polarity.
Cutting the LED Strip
The LED strip can be cut with scissors
every
10 cm at the cutting marks to get desired length.
Always disconnect the devices from the power
supply first.
