8
Warning! Socket outlets or external power switches used to supply this light with power must
be located near the fixture and easily accessible so that the fixtures can easily be disconnected
from power.
Important! Do not insert or remove live Neutrik PowerCon connectors to apply or cut power,
as this may cause arcing at the terminals and damage the connectors.
Important! Do not use an external dimming system to supply power to the 350BSW as this
may cause damage to the fixture that is not covered by the product warranty.
Power voltage
Warning! Check that the voltage range specified on the fixture's serial number label matches the local
AC mains power voltage before applying power to the fixture.
This light fixtures accept AC mains power at 100-240 V nominal, 50/60 Hz. Do not apply AC mains
power to the fixture at any other voltage than that specified on the fixture's serial number label.
Data link
A DMX 512 data link is required in order to control a 350BSW via DMX.
This light has 5-pin XLR connectors for DMX data input and output. The pin-out on all connectors is pin 1 = shield,
pin 2 = cold (-), and pin 3 = hot (+). Pins 4 and 5 in the 5-pin XLR connectors are not used in this light but are
available for possible additional data signals as required by the DMX512-A standard.
Standard pin-out is pin 4 = data 2 cold (-) and pin 5 = data 2 hot (+).
The number of fixtures is either limited to 256 or limited by the number of DMX channels required by the fixtures
in relation to the maximum 512 channels available in one DMX universe, whichever limit is lower. Note that if
independent control of a fixture is required, it must have its own DMX channels. Fixtures that are required to
behave identically can share the same DMX channels.
To add more fixtures or groups
Summary of Contents for HL-BSW380
Page 4: ...4 Dimensions ...