00055335.DOC, Version 1.3
21/23
Addressing
Each device occupies 8 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the starting
address via the control board.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the CRT-120 starts running.
Via the function buttons, you can select the desired mode:
[ALL-] All On
: all LEDs are on at the same time
[PU--] Program
: selection of the different programs.
[SP--] Speed
: the controller runs through the program. The program speed can be adjusted fro 1 to 20.
[Addr] DMX
: adjustment of the DMX-address between 1 and 512. The LED curtain is controlled via the
connected DMX-controller.
[Soud] Sound Control
: the controller runs sound-controlled through different programs.
Selection of the different programs
RGBY-version
White LED version
Program 1
color shade and change
color shade and change
Program 2
all LEDs shade
all LEDs shade
Program 3
color change
color change
Program 4
strobe and change
strobe and change
Program 5
all LEDs change
all LEDs shade
Program 6
Red color on
one color on
Program 7
Green color on
one color on
Program 8
Blue color on
one color on
Program 9
Yellow color on
one color on
Program 10
Red + green color on
two loops white color on
Program 11
Red + blue color on
two loops white color on
Program 12
Green + blue color on
two loops white color on
Program 13
Red and yellow color on
two loops white color on
Program 14
Red color strobe
white color strobe
Program 15
Green color strobe
white color strobe
Program 16
Blue color strobe
white color strobe
Program 17
Yellow color strobe
white color strobe
