00028194.DOC, Version 1.0
21/24
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After connecting the device to the mains, the LED Flood Light 432/10 RGB starts running. This unit has two
operating modes. It can be run DMX-controlled or as a Stand Alone-unit. In the Stand Alone mode, LED
Flood Light 432/10 RGB can be used without a controller.
First, “WELCOME TO USE” appears on the LC-display and the unit is carrying out a self-test. Press MODE
to enter the main menu.
Navigate through the menu
Press MODE to navigate through the 5 points of the main menu of the LED Flood Light 432/10 RGB.
1. 01- 14 - Internal programs
Under this point of the menu, you can select one of 14 internal programs
(chasers). A chaser is a sequence of different steps that will be called up one after
another in a continuos loop. The chaser speed (S) and the strobe speed (F) is also
adjustable between 1-100. Use button SET UP to jump from input value to input
value and define the values with buttons UP/DOWN.
2. AUTO RUN - Automatic Color-Change
With this point of the menu, you can activate the automatic color-change. In Auto
Mode the chasers are called up automatically in a continuous loop. The frequency
(FQN) of the loops can be defined via buttons UP/DOWN between 001 and 100.
3. DMX MODE - DMX-controlled mode
The control board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED Flood Light 432/10 RGB will respond to the lighting controller. Under this point of the menu,
you can define the DMX starting address and the DMX mode.
Setting DMX starting address
To define the starting address, you have to be in DMX-mode. Press MODE until
the display indicates “ADDR: 001”. Set a value between 001 and 512 via buttons
UP/DOWN.
After having addressed the LED Flood Light 432/10 RGB, you may now start
operating it via your lighting controller.
Setting DMX mode
Press SET UP and to determine a DMX mode. Select mode 5, 8, 14, 17 or 26 via
buttons UP/DOWN.
DMX protocol
