Euroheat Hwam Classic 4, Installation Instructions & User Manual

Page: 9 / 16

23
f
IrIng manual
–
wood
Your first heating session
When you light up for the first time, you must do this very carefully as all materials must be heated
gradually. The door and the ashpan should be opened very carefully as there will otherwise be a risk
that the gaskets will stick to the lacquer. The coating on the stove will be cured the first time the stove
is lit, and this may create an odour. Ensure for adequate ventilation.
D1. Firing (Drawing D)
1. The regulation rod (3) is pushed farthest to the right.
2. The sliding damper (2) in the door and the by-pass damper (1) are opened. Always pull out the
by-pass damper before opening the door.
3. Place 2 firelighters at the bottom of the stove. On top of this, place an amount of split kindling
wood equivalent to two logs (not more than 2 kg). Now light up. Keep door slightly open until
there is no more condensation (approx. 5 – 10 minutes). Shut the door. When the kindling wood
burns well, the regulating rod (3) is placed in middle position. Let the kindlings burn out till there
are no more visible flames.
Important!
Do not open the ash pan when lighting up and always keep it closed when the stove is in use, if not
you can destroy the automatic control.
D2. Continous use
4. When there are no more visible yellow flames, and a right ember is there, you can fire again. A
right ember is when the whole bottom is covered, and the glows are lighting in a ring around the
shaking grate. Add 2 – 3 pieces of firewood (max 2 kg). At first firing, the sliding damper (2) in the
door is regulated down to half open.
5. When there are visible yellow flames again, the regulating rod (3) of the automatic air flow regu-
lating system is pushed back to middle position.
6. When in continuous use, no further regulation is necessary. This is done by the automatic air flow
regulating system giving an even, constant burning. But if you want more heat, the regulating rod
is pushed further to the right, and if you want less heat, the regulating rod is pushed further to
the left. However, you may never close the primary air supply completely. When the stove is cold,
all dampers are closed.
f
IrIng In general
Rapid or fierce heat
Rapid or fierce heat is obtained by burning many small pieces of wood.
Maximum amounts of fuel
The stove is approved for a maximum hourly burning of 2,0 kg wood or 1,6 kg briquettes
If these limits are exceeded, the stove will no longer be covered by the factory guarantee, and it may
also become damaged due to excessive heat.
Prolonged burning time
Prolong the burning time by burning a few (at least 2) very large pieces of wood while at the same
time closing the thermostatic control. The burning time can also be prolonged by setting the sliding
damper in the door to half open, though never more than would make the glass pane sooty.