●
Error indication
The status
indicator
If there is an error with the system when it is powered up,
then the status indicator will flash red; the number of
flashes will indicate the type of error.
The table below describes the error indication, and a few
possible actions that can be taken to rectify the problem.
The actions listed are not in any particular order and are
suggestions only; the intention is that one of the
suggestions may help you clear the problem. If in doubt,
consult your supplier.
Flash
code
Error description
Possible action
1
Remote / joystick
Check cables and connectors Replace Remote
2
Network or
configuration error
Check cables and connectors
Check Bluetooth pairing
Reconfigure the system
Recharge the battery
Check charger
Replace modules
Contact supplier
3
Left motor error
Check cables and connectors
Replace Power Module
Check and/or replace left motor
4
Right motor error
Check cables and connectors
Replace Power Module
Check and/or replace right motor
5
Left park brake error
Check cables and connectors
Check left park brake is released
6
Right park brake error
Check cables and connectors
Check right park brake is released
7
Module error (other
than Remote)
Check cables and connectors
Check modules
Replace Power Module
Recharge battery
If the chair stalled, reverse away or remove obstacles, or
if the chair was moved while turned off, cycle the power.
The error indicator may continue to flash after an error has been
rectified.
To clear the error indication, cycle the system's power.
- 31 –
FOLD THE WHEELCHAIR
●
Unplug the battery connector Q, undo the strap and remove the
battery.
●
The battery must be taken out first and installed last –when
assembling the drive mount.
For Lithium Battery
●
Unplug the battery connector,
Pull knob backward and pull up
●
Unplug the battery the battery handle for removing
connector, undo the strap lithium battery as illustrated.
and remove the SLA battery.
For SLA Battery
●
Pull out the cable connector P2 as indicated. (Refer to P.33)
- 32 –
