82
GB
OPERATION
Setting the cutting height
Warning!
Stop, release switch lever and wait until the motor stops
before adjusting height, the blade continues to rotate for a few seconds
after the machine is switched off, a rotating blade can cause injury.
For the first cut of the season, a high cutting adjustment should be selected.
The cutting height can be selected among 20 mm,35 mm or 50 mm by adjusting the wheels.
Setting the cutting height
For best results, always adjust the cutting height of your mower to suit the mowing conditions
and do not try to remove too much grass in one pass.
Wheel adjustment
Turn over the machine, press the axle of wheel with two hands and make it out of the notch,
then relocate it in the required position.
Fig.13
Adjust the front and rear wheel in the same way so that the front and rear wheels are in the
same plane.
Important: All 4 wheels have to be set to the same cutting height.
Note:
1.
Set the axle in the upper position for the lowest cutting height. The
middle position for the medium height and lowest position for the
highest cut.
2.
The lowest cutting height is only suitable for trimming a very short
lawn, high and medium positions are recommended for normal use.
Never use the mower with the wheels set in different positions.
3.
For the first cut of the season, a high cutting adjustment should be
selected.
Power connection
The mains voltage (230V) indicated on the rating plate must correspond with the mains power
supply. Mains connection fuse: min.10A.
1) Insert the mower plug into the socket of the unit connection cable.
