Euroclima ZHK, Manual

Page: 33 / 142

Instruction Manual ZHK
32/140 V07-21.0
Lifting with monobloc crane lifting lugs
-
In the counter frame are drilled holes for mounting monobloc crane lifting lugs with bolt connec-
tions. The bolts will be mounted already by EUROCLIMA, if this option is agreed. (
Figure 24
).
-
The crane lugs are included in the scope of delivery of EUROCLIMA, if the lifting of the mon-
obloc by crane lugs is agreed.
-
In accordance with the length and the weight of the monobloc AHU 2, 3 or more crane lifting
lugs have to be mounted at each side of the AHU.
-
The weight must be applied evenly over all monobloc crane lugs.
-
Remove the crane lugs after pre-positioning the AHU.
Figure 24:
Factory-made preparation for monobloc lifting lugs
Figure 25:
Positioning of the monobloc
crane lifting lug at the counter frame
Figure 26:
Fixing of the metal sheet
and the monobloc crane lifting lug
with nuts
Figure 27:
Monobloc crane lifting lugs
mounted
WARNING!
The lifting of monoblocs is just permitted for the case described above, with the
particular crane lugs delivered by EUROCLIMA.
3.6 Lifting when heat wheel or plate heat exchanger casing is delivered in parts
According to the agreed AHU drawing, the casing of the heat wheel or plate heat exchanger sec-
tion is delivered disassembled.
3.6.1 Assembly order of disassembled delivered casing parts
The following instructions and order must be observed when lifting or assembling the crane lugs of
these casing parts (see also
Figure 28
):
1. Lifting of the bottom casing part: only base frame crane lugs are allowed be assembled on
the bottom casing part (see
chapter 3.4.3 (Mounting of base frame crane lugs)
).