Euroboor LKF.200, Safety Instructions And Operator'S Manual

Page: 6 / 10

SETTING REQUIRED ANGLE AND WIDTH OF CUT
There are two adjustments mechanisms:
1. for adjusting the beveling angle required,
2. for adjusting the machine to the thickness of steel which is being cut.
- Before you start any adjustments make sure that the machine is
unplugged from the main power.
- To change beveling angle loosen two M8 bolts (#12) located on both
sides of the milling head housing and interlocking vertical and horizontal
slides. Then change position of two slides setting the required angle
according the pitch marked on the side of the housing. After setting the
right angle tighten all bolts (#12).
- The width of cut can be set by turning bolt (#7) which will after the position
of the milling head. Do it by loosening two bolts (#22) located on the side
walls of the housing and turning the bolt (#7). Then tighten (#22) bolts.
The pitch shown on the side of (#9) housing gives only approximate
parameters. Precise beveling width should be adjusted empirically by
appropriate adjustment of the housing (#9).
HOW TO CHANGE INSERTS
1. Machine LKF. 200 is equipped with a double milling head, containing
twelve cermetalic inserts. Recommended inserts are of the following type:
LKS.10, LKS.10T, LKS.10R, LKS.10G
2. I case of average quality construction steel, life expectancy of those
inserts is around 150 running meters per each side of inserts. before you
replace tips for new ones make sure that all four sides of each insert were
used. To do it, undo bolts (#22), take the housing (#9) off the machine.
Use the Allen wrench – size 3 (supplied as standard) to loose bolts (#28)
and remove the inserts (#29). It is normally not necessary to take both
milling heads (#25) off the spindle (#23).
3. When changing tips make sure that all inserts (#29) newly placed in the
milling head (#25) are installed square and that are pushed as far back
(into the holder) as possible. Before pushing new inserts into the milling
head always remove all swarf. drawing No 3 shows how inserts should
overlap each other. Make sure that the necessary gap of 0,2 mm is
always made.
4. If both milling heads (#25) were removed and the replaced on the main
shaft (#23) make sure that they are installed in the right direction and that
tips of each milling head are shifted relatively to each other for smoother
work.