Euroboor EDC.135, Manual

Page: 13 / 16

13
Basic Saw Operations (continued)
Workpiece clamping
Positions work in vise so that if jam occurs. The blade shall
not tend to move the workpiece in the vise. Clamp it
securely.
Angle bar should be clamped in position as shown Fig.19.
Generally the saw cut most efficiently if the blade is cutting
the thinnest section at any time as shown Fig.20.
Ο
×
Recommended Cutting Capacity
WARNING:
Use of tool for greater than recommended capacities may lead to motor burnout and possible
electric shock.
Note:
Cutting through any cross sectional area of material thicker than 12.7 tends to load up the blade, and this will
cause your tool to work harder.
Applicable Blade
Dimensions
355mm(14”) Outer Diameter × 25.4mm(1”) hole diameter
AT 45 Degrees AT 90 Degrees
Work piecs
Configuration
(Cross-Section)
● ■
▬
● ■
▬
Maximum Cutting
Capacity
(Shown as Fig.16)
4.4”
(112mm)
3.6” × 3.6”
(92 × 92mm)
4.4” × 3.6”
(112 × 92mm)
4”
(102mm)
4.7” × 7.4”
(120 × 120mm)
7” × 3.6”
(178 × 92mm)
Maximum Cutting
Capacity
(Shown as Fig.17)
N/A N/A N/A
5”
(127mm)
3.7” × 3.7”
(95 × 95mm)
8.6” × 3.6”
(220 × 92mm)
Fig.20
Fig.19