www.euroboor.com
25
5.2 Rotating and replacing cutting plates
Each of the 3 cutting plates on the milling head have 3 usable sides. When the used side of either of
the 3 cutting plates is dull, the cutting plates can be rotated to position a sharp side in the correct
direction.
[image 4-2]
Rotating cutting plates:
1.
Remove the milling head as described in previous paragraph: Changing or replacing the
milling head.
2.
Clamp the milling head in a vice on the far outer rim.
3.
Mark dull side on all 3 cutting plates.
4.
Undo mounting screw with the supplied L-type Torx wrench.
5.
Take of cutting plate, rotate 120° and put it back in place.
6.
Fasten the mounting screw with the supplied L-type Torx wrench.
7.
Refit the milling head and other components as described in previous paragraph: Changing or
replacing the milling head.
WARNING:
Always rotate the 3 cutting plates at the same time.
WARNING:
Always replace the 3 cutting plates at the same time, using the same brand and
type for all 3 pieces.
Milling head
Cutting plate
Mounting screw
