www.euroboor.com
24
5.1 Changing or replacing the milling head
The Beveling machine is standard equipped with a 45° milling head. When showing signs of wear, a
replacement piece (part number B45.1011) can be ordered from your EUROBOOR reseller.
For every type of milling head the replacement procedure is the same.
1.
Loosen the clamping ring lever.
2.
Rotate the entire support deck assembly until it comes off the machine.
3.
Use the supplied spanner 22 mm to hold the spindle in place.
4.
Use the supplied C-spanner to loosen the milling head, and turn it off the machine.
Assembly in reversed order. Always check for damaged or worn-out parts and replace them when
necessary. Always clean and lubricate parts prior to refitting.
[image 4-1]
