Overload
The motor of your right angle grinding machine may be damaged when overloaded. This results from excessive working pressure over a
prolonged period. Therefore you should not try to accelerate your working speed by increasing pressure on your machine. The abrasive disks
work more efficiently if only slight pressure is exerted on the grinding machine, thus avoiding a drop in the grinding speed.
Maintenance
• The protective cover, air slits and motor housing should be kept as free of dirt and dust as possible.
• Rub off the device with a clean cloth or use compressed air at a low pressure to blow out any dust or dirt. Excessive amounts of metal dust
may result in electricity from the internal components being conducted on to exposed metal parts!
• Do not subject the grinding machine to any overload! Overloading will lead to a reduction in the speed and performance and cause the
machine to overheat! If this should happen, switch the grinding machine off and let it cool down for approximately 30 minutes or to room
temperature!
NOTE:
Turning off the grinding machine while it is being subjected to a load will reduce the working life of the operating switch!
Cleaning and Care
• Before cleaning the machine, remove the mains plug from the socket and
release the switch trigger (1) to power off the tool
• For cleaning purposes, only use a slightly damp but not wet cloth!
• Do not use any abrasive additives (petrol, turpentine etc) as these may damage the plastic housing!
• A mild soap is suitable for cleaning the machine!
• Ensure that no moisture is allowed to get inside the machine!
• After cleaning, wipe the machine with a dry cloth!
EC Conformity Declaration
We hereby declare that the angle grinder AGR.1400 fulfils the requirements of directive: 2006/42/EC, 2006/95/EC, 2004/108/EC
This appliance conforms to the CE directives for radio interference suppression and low voltage safety and has been built to meet current safety
requirements. Subject to technical changes without prior notice!
Technical Data
Model
AGR.1400
Rated input
230V~50Hz
Rated power
1400W
No load speed
8500/min
Disc size:
125mm
Class of tool
回
Sound pressure level(Lpa)
89dB(A) K=3 dB(A)
Sound power level(Lwa)
100dB(A) K=3 dB(A)
Vibration
4.53m/s
2
K=1.5 m/s
2
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
Summary of Contents for AGR.1400
Page 1: ...MANUAL AGR 1400 Euroboor Angle Grinder ...
Page 5: ......
