22
461308002 (RS-001) 05/201
1
�
�
�
�
�
�
26
INSTRUCTIONS FOR THE INSTALLER
MAINTENANCE
Prior to any maintenance work or changing
parts, disconnect the appliance from the gas
and electricity power sources. Servicing must
only be carried out by authorised personnel.
REPLACING THE TAPS AND THERMOSTAT (fig. 26)
Proceed in the following way when replacing a tap or
the thermostat:
• Remove pan supports, burner heads and knobs.
• Unscrew the burners securing screws.
• Remove the lateral sides, lid and hob.
• Unscrew the check nuts of rails (D) and/or of any
thermocouples and remove tap (R) or the thermostat
(T) by unscrewing the screws (V).
• Partly remove the burners small supply pipes and
change the relative part.
• Replace the seal (G) each time you change a tap or
thermostat so as to guarantee a perfect fit between
body and rail.
• Reassemble all the parts following the same
procedure but in the reverse order.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
it on the date you will find printed on it.
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed in order
to change the lamp holder, terminal board and
power cable.
•
If you have to change the pow
er cable (see the
cross section on table on page 25), always keep
the earth wire longer than the ph
ase wires and,
in addition, follow all the instructions given in
the “ELECTRICAL CONNECTION” paragraph.
• To change the oven lamp see the instructions
given in the paragraph «
REPLACING THE OVEN
LAMP»
..
•
To change lampholder of type 1
(
fig.13A
), remove
the side panels and then
use a screwdriver to push
the two locking tabs (fig.27) and remove the lamp
holder from the inside of the oven.
•
To change the lampholder of type 2
(fig. 13B),
unscrew the protective glass cap (C), force the tabs
of blockage and take the lamp-holder toward the
inside of the oven.
• To change the spark generator the left side of the
cooker has to be removed.
• To change the programming accessory, the
microswitches, the spark generator and the spark
electrodes, the work top has to be removed.
�
�
�
27
Summary of Contents for EG600FS2X
Page 24: ......
