1.
it is secure.
Check the connection and ensure
2. Change the temperature sensor.
1. The connection between the
temperature sensor and wire is
not secure.
2. The temperature sensor is damaged.
1. Check the connection and ensure
it is secure.
2. Change the heating tube.
1. The connection between the
heating tube and wire is not
secure.
2. The heating tube is damaged.
1. Check the connection and ensure
it is secure.
2. Check if the machine is overloaded.
Switch off the machine, and retry
when the motor becomes cool.
3. Change the motor.
1. The connection between the
motor and wire is not secure.
2. The motor is protected because
of over-heat.
3. The motor is damaged.
1. Change the water inlet.
2. Check the connection and ensure
it is secure.
3. Change the water sensor.
1. The water inlet valve is damaged.
2. The connection between the
water sensor and wire is not
secure.
3. The water sensor is damaged.
Possible Cause
The machine
fills overtime.
There is a Door
lock alarm.
1. The water tap is not open.
2. The drain hose is put down.
3. The water inlet valve is damaged.
1. Open the water tap.
2. hook up the hose.
3. Change the water inlet valve.
“Spin”
LED
flickers.
Problem
Error Code
The machine
drains overtime.
Water overflows
the machine.
/ Water sensor
works abnormal.
The motor does
not work.
There is a
heating tube
fault.
There is a
temperature
sensor fault.
“Rinse”
LED
flickers.
“Rinse”
and “Spin”
LEDs flicker.
“Washing”
LED
flickers.
“Washing”
and “Spin”
LEDs
flicker.
“Washing”
and “Rinse”
LEDs
flicker.
“Washing”
, “Rinse”
and “Spin”
LEDs
flicker.
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system
and clean it.
1. The
drain
hose
is
squashed
or
kinked
.
2. The drain pump filter is block.
3. The
drainage
system
pipes
are
blocked
.
1. Lock the door well.
2. Put the garment into the drum.
3. Change the door lock.
1. The door is not locked well.
2. garment is caught between the
door and the seal.
3. The door lock is damaged.
Use pointed nose pliers to withdraw the plastic filter.
Clean, put back and secure. These filter should be
checked every 6 months or so, or more often if there
are frequent interruptions to the water supply.
Important:
If the machine is exposed to temperatures below 0°C, certain precautions
should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position the end of this
hose and that of the inlet hose in a bowl. Run the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure that the room
temperature is above 0°C.
The filter should be cleaned every 2 months or so,
or when there is a fault that the “Rinse” and “Spin”
LEDs flickers for A2 series and “E3” is lighted up
on the screen for A5/A8.
The filter must be put back in place after cleaning.
3. Clean the filter carefully.
2. Place a container under
the pump. Unscrew and
remove the filter.
1. There are two kinds of lower
covers for different models.
Disconnect the machine
from the mains electricity
supply and open the lower
cover with a screwdriver
following the drawings above.
Type A
Type B
