10
OPERATING INSTRUCTIONS
Care And Maintenance
To improve the performance and life of your unit, we recommend you do the
following:
1. Once a month clean the unit with a dry cloth, including the chamber which the dust
container fits into. Remove any hair, fiber or other materials that may have built up
in the chamber, and on the rotating brush.
2.
Don’t
use abrasive materials to clean the sweeper.
Do not immerse the unit in
water.
3.
Do not
pick up liquids or use on wet floors.
4.
Do not
use on concrete, tar or similar rough surfaces.
5.
Don’t
pick up pieces of string or fabrics with the sweeper.
6.
Do not
clean tasseled or frayed carpets with the sweeper.
Fig. 15
8.
Slip the belt over the brush bar cap.
9.
Insert the brush bar into the slot. (Fig. 14)
10. Insert the gear box tabs into the tab slots and push down until it clicks into place.
11. To replace the squeegee, follow instructions above for removing the gear box and
slide the squeegee out from left to right. (Fig. 16)
Changing the Belt
If you find that the belt has broken and it needs replacing:
1.
Remove the brush cover. (Fig. 11)
2.
Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 12 & 13)
3.
Push in on the locking tab of the belt access panel and lift off to remove. (Fig. 17)
4.
Using a pair of tweezers, remove any leftover bits of the belt that might still be
there.
5.
Pull the brush bar out of the bushing. (Fig. 14)
6.
Using a new belt, insert it into the opening until it is in all the way.
7.
Using a pair of tweezers, insert them into the belt access panel and lift the new belt
over the back gear.
8.
Slide the belt over the brush bar cap and then insert the brush bar into the slot.
(Fig. 14)
9.
Insert the gear box tabs into the tab slots and push down until it clicks into place.
10. Press the belt access panel down until it snaps in place.
11. Replace the brush cover. (Fig. 11)
Belt Access Panel
Fig. 16
Insértelo dentro
del mango
inferior
Fig. 1a
Fig. 1b
Fig. 1
1. Arme los tubos de extensión insertando el extremo de plástico dentro del otro
tubo de extensión. (Fig. 1a) Presione hasta que se vea solo una pequeña parte
del extremo de plástico o hasta que no se pueda insertar más dentro del tubo.
Enganche el tubo de extensión al mango superior. (Fig. 1) Coloque el tubo de
extensión en el mango inferior de modo que la “pestaña” del inserto de plástico
encaje en la ranura del mango inferior. (Fig. 1b)
Armado de su Barredora Inalámbrica
Su barredora inalámbrica requiere muy poco armado. Deberá sacarla de la caja y
familiarizarse con todos los componentes listados en el diagrama descriptivo. (Pág. 12)
Esto le ayudará en el armado y operación de su barredora inalámbrica.
Nota
: El cargador puede venir guardado dentro del recipiente para la tierra.
15
INSTRUCCIONES DE USO
Nota
: El tubo de extensión inferior tiene el extremo de plástico diferente. Éste
tubo debe insertarse primero que los demás.
2. Coloque el mango en la posición vertical de almacenamiento.
Summary of Contents for Shark CORDLESS V1917N
Page 2: ......
