CHARCOAL FILTER
IMPORTANT:
A charcoal filter must be installed in the microwave oven when it is used in a non-
vented (recirculating) installation. Your microwave oven comes from the factory with the
charcoal filter installed.
The charcoal filter cannot be cleaned, so it must be replaced at least every 6 months or more
often depending on use. To order a replacement charcoal filter for your model, contact the
Customer Satisfaction Center. See “Back Cover” for contact information.
1.
Unplug or disconnect power.
2.
Using a Phillips screwdriver, remove screws from the top grille.
3.
Open the microwave door so you can grasp the top grille, and then pull the grille straight out to remove.
4.
Remove the used charcoal filter from the back of the grille, and then discard the filter.
5.
Align the holes in the new charcoal filter with the five posts on the back of the grille, and gently press down to attach.
A
Charcoal Filter
6.
Align the top edge of the grille so that when the grille is pushed into place the screw hole tabs on the the grille will align with the
holes in the microwave cabinet. Gently push on the grille until it snaps into place and the screw holes are aligned.
NOTE:
Make sure that the wire harness, located near the door hinge, is not pinched
when you are replacing the top grille.
a b
b
A
Wire Harness (not shown)
B
Screw Hole Tab (2)
7.
Replace the two
and
screws.
LIGHTS
IMPORTANT:
Your microwave oven features LED interior lighting as well as LED surface
lighting. These lights are designed to last for the life of your microwave oven. However, if
the lights stop illuminating, please contact a qualified technician for replacement or the
Customer Satisfaction Center for service. See the back cover for contact information.
15
screws removed earlier,
completely tighten the
