EURO-Jabelmann V 4000K, Operating Instructions Manual

Page: 6 / 11

6
7. Assembly and Start-Up
7.1. Assembly of the Machine
Place the machine on a flat and even surface and
the feet to the desired height. The front and back feet must be the same height. Check the screw joints for
tightness.
Before connecting to the electric circuit, check whether the energy grid corresponds with the specification
on the motor’s rating plate.
7.2 Starting Up the Machine
Set the desired discharge height for the feed belt using a winch (photo). Ensure that the belt is always sta-
ble.
Insert the 16 Ampere plug into a suitable socket and switch the belt on using the switch (photo 4).
When starting the machine up, ensure that the belt is running in the right direction.
If the belt is rotating in the wrong direction, the
rotation direction of the motor is to be reconnected on the mains plug.
This is to be done by trained professionals only!
After the belt has started, you can pour the material that is to be transported into the hopper.
Before you finishing working with the machine, it is important that you let the belt run empty and that no
material remains on the belt.
Should the motor circuit breaker trip, this is probably the result of you having put too much material into
the machine.
Reduce the quantity if this happens.
8. Maintenance and Repair
IMPORTANT
Switch off the motor and disconnect from the mains
before any repair or maintenance work is carried out.
8.1. Maintenance and Lubrication
The lubricating points on the bearings are to be lubricated
regularly. This is regardless of how often the machine is used. Switch off the machine and disconnect from
the mains before lubricating the machine.
8.2. Repair work
IMPORTANT
Repair work is only to be carried out by
trained professionals!
8.3. Tension the conveyor belt
Should the belt pull on the protective plates at the side, it is useful to tension the belt.
In addition to this, the thread alignment can be easily
changed.