Eureka Europa 6900 Series, Owner'S Manual

Page: 12 / 20

Brush Roll
The brush roll turns to sweep and comb the carpet nap. Keep the brush roll free from hair and threads so it will continue
cleaning. When the bristles of the brush roll no longer touch a piece of cardboard held across the bottom plate, the brush roll
is ineffective because the bristles no longer touch the carpet nap. To maintain the most effective cleaning, install a new brush
roll.
Brush Roll Belt and Light Bulb
The brush roll belt on the motorized nozzle drives the brush roll to agitate, sweep, and comb the carpet nap. The belt should
be checked regularly to be sure that it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away
any hair or thread wound around the brush roll or belt pulley because the buildup could cause the belt to rotate unevenly.
How to Replace Worn Belt or Light Bulb
(On Some Models)
Note: Turn off the switch and unplug the electrical cord before replacing belt or bulb. Pulleys can become hot
during normal use. To prevent injury, avoid touching the pulleys when servicing the drive belt.
1. Remove four screws from bottom side. Turn unit over;
pull up on hood to remove.
Replace light bulb, if necessary. Use GENUINE
EUREKA replacement bulb (refer to customer order
form).
Continue to step 2 to change belt. Skip to step 7 to
replace hood.
2. Lift out brush roll and discard used belt.
3. Put new belt around brush roll pulley first; then the
motor pulley.
4. Place left end cap into the base.
5. Pull right end of brush roll to stretch belt. Secure right
end cap into base.
6. Rotate brush roll to seat belt.
7. Position hood; secure with screws.
Motor Pulley
Brush Roll Pulley
Look for the symbol.
Use GENUINE EUREKA replacement belt, 58065.
12
{
{
{ {
{
{