3
INSTALLATION GUIDE
Preparation:
Check the following list of components to ensure that all parts are packed with your
system.
1. Storage tank
2. RO system
3. Faucet & Faucet mounting bracket
4. Installation Kit
1.
2.
INSTALLATION OF WATER SUPPLY CONNECTOR
Make sure that you are nooKing up to the cold water. Determine tne location fof the
installation of the RO system. Avoid locations where the system might come in contact,
with hot water pipes or other hazards as like sun light.
Determine the location for the faucet. Check to see that drilling the faucet hole will
not damage pipes or wires running underneath the sink.
Upper sink fitting this system then use the faucet mounting bracket.
Determine the location for the storage tank. A maximum distance from the tank to
faucet is 15 feet. The system will produce the faster flow at the faucet with the
shortest tubing run from tank to faucet,
Do not place unit where it will be exposed to freezing an:i or direct sunlight. Mourn
the unit, on the side ol 'Tie cabinet usina biackct (attached to unit) & two screws
(provided m kit)
The water supply connector comes with the unit installation kit.
Disconnect the water supply line from the cold water tape and attach and tighten
water supply connector assembly.
if you install upside the sink then remove your existing overhead water tank top,
attach & tighten water supply connector assembly.
Single Assembly Valve
Fig. 1
Eureka Forbes Water Purification System
