SD20-G Series
55
4.1.3 Typical main circuit wiring examples
For 220V servo drive
Alarm relay
RLY normally-
open contact
Contactor KM1
Normally-open
contact
KM1
L1
L2
L3
L1C
L2C
B2
B3
N+
N-
B1
QF circuit breaker
U
V
W
Three-phase AC
220V power supply
*
PE
M
PG
ALM+
ALM-
+24V
0V
Alarm relay
RLY
CN1
CN2
CN3
Contactor
KM1 coil
Manual power on
External resistor
Servo motor
P
E
FIL filter
Manual power off
Fig 4-1-4 Typical main circuit wiring of 220V servo drive
Note:
1. Built-in resistor is default and B2 and B3 terminal is short-circuit. If external resistor is used, please remove the
short cable between B2 and B3, and then connect external resistor between B1 and B2.
2. RLY
：
Alarm-signal output relay.
3. KM1: Contactor, connect or disconnect to main circuit power supply through manual switch.
4. If absolute encoder multi-turn function is adopted, please install battery.
Note: please connect an emergency stop circuit to main circuit so that servodrive can stop and power
off immediately in case accident occurs.
Summary of Contents for SD20-G Series
