Start-up procedure:
• After the e-bike has been properly assembled, all components are secured correctly and the user has
read this entire manual, user may turn on the e-bike and select a power level as outlined below:
• Test the battery lock security. Ensure the key port is locked indicating the battery is securely in place
inside the frame.
• Remove the key. Carefully use both hands to test that the battery is securely locked into place.
• Make sure that handlebars and seats are properly adjusted. Note that lowering the seat so that the
rider can put one or both feet flat on the ground without dismounting from the seat may offer a safer
introduction to operating the e-bike.
• Ensure handlebar faceplate bolts and seatpost quick release are fully secured.
• Turn the e-bike on by holding the M on the mode selector on the left hand side of the handlebar.
WARNING:
The key must be removed from the battery before mounting or operating the ebike. Leaving the
key inserted in the key barrel while mounting or dismounting, while removing an unlocked battery from the
frame, and/or while operating the ebike can cause damage to the key or battery, and can cause damage to
property, serious injury and/or death.
1. Turn on the headlight and taillight if needed by holding down the up arrow. A light indication will appear
on the screen indicating that the lights are now on.
2. Select the desired level of pedal assistance between level 0 through 5 using the up and down arrows on
the LCD display remote. Level 0 indicates pedal assistance is inactive. Level 1 corresponds to the lowest
level of pedal assistance. Level 5 corresponds to the highest level of pedal assistance. Start in PAS level 0
and adjust from there.
3. Begin riding carefully. With proper safety gear, prior experience in bicycle riding, and after reading this
manual in its entirety, the rider may now operate the Euphree ebike. On a flat surface, most riders
should be able to begin pedaling the ebike with pedal assist level 0 or 1. You may also gently use the
throttle to accelerate or maintain desired speed.
4. The throttle is used by slowly, gently and carefully pressing down the thumb into the throttle lever. The
throttle is active when the ebike is turned on. Do not use the throttle unless you are riding the ebike.
WARNING:
Never use the throttle while dismounted. While dismounted and moving the ebike, ensure that
the ebike is powered off to prevent application of the throttle.
Power system
How pedal assist works:
The user can engage the pedal assist system (PAS) while pedaling. Use of the PAS will recruit assistance
from the motor and will help propel the ebike forward. PAS uses a cadence sensor built into the drivetrain.
This cadence sensor detects when the user is pedaling and signals the electric motor to provide assistance.
The user selects five levels of pedal assistance (PAS 0, 1, 2, 3, 4, 5). PAS 0 indicates no pedal assistance will
be provided.
How the throttle works:
The throttle is located on the right side of the handlebar. The user can engage the throttle by pushing down
with the thumb. To engage the throttle while riding, slowly push the throttle lever down with the thumb.
The more you push, the more powerfully the throttle will propel the ebike forward. Once you release the
throttle or apply the brakes, the throttle will no longer be engaged. Always keep on hand on the brake lever
and be prepared to squeeze the brake lever when using the throttle. You should not use your throttle if
local regulations prohibit the use of throttle on ebikes. It is the user’s responsibility to research, understand
and follow ebike regulations and all traffic law.
WARNING:
Even if you are an experienced ebike user, all users must read and implement the procedures
and information described in the owner’s manual and any manuals included with each subcomponent.
Headlight and brake light features turn on by holding the up arrow for 5 seconds.
City Robin 22 - Step-Thru
electric bike.
EUPHREE
YOU•FREE
2 0 | 2 0 2 2 M A N U A L
