R-1 Audio Deck Manual
©1999 Euphonix, Inc
.
Page 16
Setup (Standard R-1 Configuration)
The Audio Deck is recommended for the third position in the rack after the
Studio Hub (top of rack) and Pilot Computer (second in rack - below Studio Hub).
•
Attach the provided IEC compatible power cable to the IEC inlet. Attach other
end to wall outlet with appropriate plug adapter if necessary. The Audio Deck
power supply will automatically set itself to work with the voltage in your
country (110, 220, or 240). DO NOT POWER up unit at this time.
•
Attach the provided Red BNC Coax cable from the Studio Hub MADI #1 Output to
the Audio Deck MADI Input.
•
Attach the provided Red BNC Coax cable from the Audio Deck MADI Output 1 to
the Studio Hub MADI #2 Input.
•
Attach the provided yellow XLR cable from the Audio Deck AES Sync In connector
to one of the Studio Hub’s AES Sync Out connectors.
•
Attach the provided green 1394 cables from any of the three 1394 connectors on
the Audio Deck to any of the three 1394 connectors on the Pilot Computer.
Power Up Sequence
The R-1 modules can be powered up in almost any sequence. We suggest that
you monitor the LEDs on the front panels at power up to insure that the intended
settings are in effect.
We recommend that the Audio Deck is booted up third in the R-1 system after
the Studio Hub and the Pilot computer.
Wait about 10 seconds for the Audio Deck to boot fully. The drive ID indicator
lights will stop flashing when the Audio Deck is ready. The AES LED should light
steadily, indicating that the Audio Deck is receiving the Sample Rate Source from
the Studio Hub.
