EUCHNER MGBS-P-I-AP Series, Operating Instructions Manual, Page: 13 / 32

13
2527247-01-09/19 (Translation of the original operating instructions)
Operating Instructions
Safety System MGBS-P-I-AP…
EN
1
Insert actuation axis.
The snap ring A must be in contact
with the inner door handle B.
2
Fit door handle.
3
Tighten fixing screw to 2 Nm.
4
Fit protective sleeve.
4
1
2
3
A
182
D - 1 *
107
39,5
D
11,5
55,5 55,5
M4
25
0
D + 9
Example without mounting plates
Standard
protective
sleeve
Extended
protective
sleeve
Standard
actuation axis
Extended
actuation axis
Escape release
Handle module
+4 mm per mounting plate
8.2. Lockout mechanism
The lockout mechanism can be secured with padlocks (see Figure 1 ). This is intended to prevent people from being locked
in unintentionally. The lockout mechanism does not fulfill any safety function.
¨
To pivot out, press the grooved part (possible only with bolt tongue retracted).
2
Key :
1
Automatically extending lockout mechanism (optional)
Padlock ∅ min. 6 mm, ∅ max. 10 mm
Notice:
You can fit up to three locks ∅ 8 mm per lockout mechanism .
Figure 1: Lockout mechanism secured with padlock