GET STARTED
CRANK
ADJUSTMENT
CLEANING
GRINDING
Pull out crank handle
(Fig.
1) in vertical
direction.
Press
it
down horizontally (Fig.
3) until snapped into
place.
To fill in beans, press down lid (Fig. 4 and
5) and remove it. Add beans (Fig. 6,
around 30g), position lid and move slightly
until snapped into place.
To grind, please turn crank handle
counterclockwise (=CCW, see Fig. 3).
Beware of Catch-up being magnetically
attached.
Ergonomic handle to be held with 3 fingers
(beware of indentation for thumb, index
finger and middle finger).
Turn the black ring (=Adjustment Ring, Fig. 2) to the left (marking to be in line with
arrow, Fig. 6). Pull down and out (if tight, please follow instructions on next page).
Clean coneholder and burrs with a brush, then reassemble in reverse order before
moving black ring to the right / back to the stepped part or your initial setting.
Please also make sure to read the more detailed instructions on the next page.
ATTENTION /
ACHTUNG
No grinding within the DO NOT GRIND-section (Fig. 6). Turning the Adjustment
beyond this section, will separate Grinder Housing from Adjustment Ring.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
ETZINGER AG
Wirtschaftspark 44
FL-9492 ESCHEN
Phone: +423 375 8383 -
Email: [email protected]
The Adjustment (Fig. 2) consists of 88 slightly
stepped increments (à 0.02mm), marked 1-
23.
To adjust grind setting, move the black ring
between COARSE (Setting 23) and FINE
(Setting 1) accordingly (beware of marking
line).
Recommended settings
Espresso:
3-7
Filter:
9-13
Point of Reference :
1
Fig. 7
Fig. 5
etz-I®
