ETVAX 46226.310E, Installation And Operation Manual

Page: 11 / 16

9 EN
4 Installation
Before start, please make sure that the wall or ceiling is strong enough to withstand 3 times the weight of the camera. Please
install and use the camera in the dry environment. You’d better install back the lower dome less than 4 hours after removing it.
The mounting steps are as follows:
1) Loosen the screws to open the lower dome and then loosen the lock screw to remove the mounting base.
Lock Screw
2) Attach the drill template to the place where you want to fix the camera and then drill 4 screw holes and 1 cable hole (if you
want to route the cables through the mounting base) according to the drill template.
4) Fix the camera to the mounting base with the lock screw.
3) Route the cables and connect these cables. And then secure the mounting base to the ceiling or wall with screws.
Ceiling or Wall
Ceiling or Wall
5) Three-axis adjustment. Before adjustment, preview the image of the camera on a monitor and then adjust the camera accor-
ding to the figure below to get an optimum angle.
6) Adjust the Focus and Zoom screw to get a clear image (if your camera is prime lens, please skip this step).
Zoom
Focus
Pan 0-360°
Rotation 0-360°
Tilt 0-75°
EN