The unit is shipped with a
Remote Control Bypass
Plug installed. Your sunbed
will not operate without
either the bypass plug or a
remote system connected.
16
27771-01A - Page 3
On the front of each leg are two holes
for skirt mounting brackets. Locate
the two brackets and attach them as
shown with two #10-32 x 1/2” screws
and two #10-32 locking nuts each.
12
Remote Connections
Your sunbed incorporates advanced circuitry allowing it to connect and
communicate with most remote control systems. If a remote system is
to be used, first determine whether the remote system is a T-Max®
Manager Pro System or a standard remote system operating with a con-
trol relay. Follow the appropriate instructions for your system type.
The remote connection is not designed to supply or accept high
voltage, nor can it provide power to an external timer. The
sunbed’s remote interface circuitry operates on 5 volts, attempting
to connect it to any higher voltages will damage the sunbed as
well as void your warranty.
CAUTION
REMOTE PORTS
WIRED
REMOTE
PORTS (RJ-22)
WIRELESS
REMOTE
PORT (RJ-11)
T-Max® Manager Pro
The T-Max® Manager Pro offers the ultimate in sunbed control, while
allowing the tanner easy straightforward operation. Your sunbed is
configured to directly connect to this system, including the new wire-
less remote system. The circuitry inside your sunbed eliminates the
need for the T-Max® 1A or 3A when connecting to the T-Max®
Manager Pro. Your sunbed supports the auto addressing feature of the
Manager Pro and the following parameters: 5, 6, 7, 8, 9, 10, 15 and
23. See your T-Max® manual for descriptions of these parameters and
how they function.
Special Note on T-Max®
The Lumagn™ 26C requires the latest software in your T-Max Manager
Pro to properly control the sunbed. To check for this, when applying
power to the Manager Pro a 3-digit version number will appear on the
left-hand side of the screen. This must be 415 or higher. This sunbed
will only work with a Manager Pro, not an older Manager or 3A.
T-Max® Wireless Remote System
The T-Max® AP-900 eliminates wires in your salon, allowing easy
setup without hiring an electrician to run wires. It also protects your
investment from damage by isolating each unit from one another. Your
sunbed arrives “wireless ready”, which means it connects directly to
the T-Max® wireless system. Older tanning beds, and T-Max® man-
agers, also utilize this system but require a T-Max “Power Injector” (PI)
to provide the needed power to the wireless unit.
Remote System Hook-up Scenarios
Follow the diagrams on the next page to see the many different sce-
narios for hooking up your salon. If you need further assistance, call T-
Max® directly at (417) 338-5101.
Slip the slots in the bottom of the skirt onto
the skirt mounting brackets. Peel the backing
from the Velcro® pad on each top bracket
and press the top brackets to the bench
cover. Press firmly so the pads stick.
15
Peel the backing from the double-
sided tape on each skirt top bracket
and attach them to the skirt as shown.
Make sure the corner lines up with
the top edge of the skirt as shown.
13
Peel the backing from the double-sided tape on each
skirt reinforcing plate and press them onto the skirt so
the slot in the plate lines up with the slot in the skirt.
14