ETOP ATX-E15, User Manual

Page: 66 / 90

58 ATX-E15 User`s Manual
IR Transmission Delay
The choice: Disabled, Enabled (default) .
UR2 Duplex Mode
The choice: Full, Half (default) .
Onboard Parallel Port
This item allows you to determine onboard parallel port controller
I/O address setting.
The choice: 378/IRQ7
(default) , 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The choice: SPP
(default) , EPP, ECP, ECP+EPP, Normal.
SPP Sets the parallel port to function as a Standard Parallel
Port. This is the default (and slowest) option.
EPP Sets the parallel port to Enhanced Parallel Port mode.
Sometimes also called "Bi-directional"
ECP Sets the parallel port up as an Enhanced Capabilities
Port. This setting requires the use of a DMA channel
If Parallel Port Mode Select is [SPP] and [Normal] will show:
Phoenix-Award BIOS CMOS Setup Utility
Super IO Device
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
UART Mode Select [IrDA]
RxD , TxD Active [Hi, Lo]
IR Transmission Delay [Enabled]
UR2 Duplex Mode [Half]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ SPP ]
x EPP Mode Select EPP1.7
x ECP Mode Use DMA 3
PWRON After PWR-Fail [Off]
Item Help
Menu Level
►
↑↓← → ： Move Enter: Select +/-/PU/PD: Value F10:Save Esc: Exit
F1:General Help F5:Previous Value F6:Fail-Safe Defaults F7:Optimized Default