EN 26
Problem
Potential causes
Solution
Cloudy stains on the
glassware.
Combination of soft water and
too much detergent.
Use less detergent and choose the
glass cycle, which you can use to
clean glassware.
Yellow or brown scale
on the inside of the
tub.
Traces of iron in the water
may cause spotting to the tub
of the dishwasher.
Contact a manufacturer of water
softeners for a special filter.
White scale on the
inside of the tub.
Hard water.
Increase salt consumption setting.
Dishwasher detergent
is left in the detergent
compartment.
The detergent compartment is
blocked by dishes.
Load the baskets so that the dishes
no longer block the detergent
compartment. Clean the upper spray
arm.
Steam.
When opening the door.
This is possible at the end of the
cycle.
Black or grey stains on
the dishes.
Aluminium cooking utensils
have scraped the dishes.
Aluminium can tarnish.
Water remains under
the filters.
This is normal.
A small amount of water around the
drain on the rear of the tub base
keeps the seal flexible.
The dishwasher is
leaking.
Rinse agent reservoir too full
or rinse agent is leaking.
Take care not to overfill the rinse
agent reservoir. Spilled rinse agent
can lead to foam/flooding. Wipe up
spilled rinse agent with a damp cloth.
The dishwasher is not
standing level.
Adjust the dishwasher so that it is
standing level.
Error code E1
Water intake time is too long.
Faucets is not opened, or water
intake is restricted, or water pressure
is too low.
Error code E3
Not reaching required
temperature.
Malfunction of heating element.
Error code E4
Overflow.
Some element of dishwasher leaks.
Error code E8
Failure of orientation of
distributary valve.
Open circuit or break of distributary
valve.
Error code Ed
Failure of communication
between main PCB with
display pcb.
An open circuit or break in wiring for
the communication.
Should the appliance become overfilled or exhibit excessive leaking,
shut off the inlet tap and alert the service department. If all indicators
are flashing simultaneously: switch off the dishwasher immediately,
shut off the inlet tap and alert the service department.
ERRORS