EN 25
Problem
Potential causes
Solution
Contamination of the
tub.
Poor quality detergent.
Only use detergent suitable
for dishwashers to prevent
contamination.
Blocked filters.
Open the door and clean the filters.
Run the pre-wash cycle.
Rinse agent has been spilled.
Always wipe up spilled rinse agent
immediately.
Dishes are not dry.
The rinse agent reservoir is
empty.
Ensure that the rinse agent reservoir
is filled.
Improper loading.
Load the dishwasher as suggested in
the manual.
The dishwasher is unloaded
too soon.
Do not unload your dishwasher
immediately after washing. Open the
door slightly so the steam can come
out. Wait for the inside temperature
to be safe. Unload the lower basket
first.
Incorrect cycle.
A short program with low temperature
can have worse washing and drying
results compared to a longer program
with a higher temperature. Select
another wash cycle.
Dishes and flat objects
are not clean.
Incorrect cycle.
Select a higher cycle.
Baskets are incorrectly loaded. Make sure that the detergent
compartment and spray arms are not
obstructed by large dishes/pans.
Spotting and scaling
on glasses and flat
dishes.
Extremely hard water.
Incoming water temperature
is low. The dishwasher is
overloaded.
Baskets are incorrectly loaded.
Old or damp detergent. Rinse
agent reservoir is empty.
Incorrect detergent dosage.
To remove spotting from glass
objects: Remove all metal objects
from the dishwasher. Use the
prescribed quantity of detergent.
Select the longest cycle. Allow the
dishwasher to run for approximately
18 to 22 minutes. It should by then
have reached the main wash cycle.
Open the door carefully and pour
2 cups of white vinegar into the
base. Close the door and allow the
dishwasher to complete its cycle. If
vinegar does not work: Repeat the
above steps, but use a quarter cup
(60 ml) of citric acid crystals in place
of white vinegar.
ERRORS
