EN 8
Selecting the ‘3-in-1’ cycle
The dishwasher features a 3-in-1 cycle. If you select this cycle
(button 5), the dishwasher does not need to be filled with salt and rinse
agent, but rather you use so-called 3-in-1 dishwasher tablets in their
place.
Pre-rinse
The pre-rinse program allows you to improve the cleaning result for
extra dirty dishes. You can set this program both independently from
and in combination with another program.
Indicators
• Water softener.
The indicator shows that you have to fill the salt container with
regeneration salt.
• Detergent.
The indicator shows that you have to fill the detergent reservoir.
• End program.
The indicator shows that the washing program has finished.
In addition, a sound signal will be heard five times.
Stopping or changing a wash cycle
1. Open the door.
The last selected program appears on the display.
2. Press and hold the programming button for more than 3 seconds.
The ‘End program’ indicator is blinking. ‘1’ appears on the display.
3. Close the door of the dishwasher.
The machine pumps out for about 30 seconds. Following the end
of this, an alarm signal will sound and the indicator shows that the
program has finished.
4. You can again select the desired program (see program selection
table).
5. Now close the door.
Note!
A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
OPERATION
