ETNA T303ZT, Instructions For Use Manual

Page: 31 / 68

EN 15
Symptom Possible cause Solution
Error code ER03. The control panel is dirty or
has water on it. Clean the control panel.
Error code E3. Unsuitable pan used. Use a pan suitable for
induction cooking.
Error code E2. Appliance over heated. The appliance has been
switched off because of over
heating.
Fault code E6. The appliance has been
connected incorrectly and/or
the mains voltage is too high. Have your connection
changed.
The fuse in the appliance will
blow if all 4 cooking zones are
used on a high power level. Appliance is connected to
a 1 phase/16 Amp and not
adjusted to "Lo" by software. Set the appliance to "Lo"
(power limiter). Refer to the
installation instructions.
Zone(s) don't work or don't
heat up sufficiently. Appliance is connected to
a 1 phase/16 Amp and not
adjusted to "Lo". The appliance's inbuilt power
limiter limits the maximum
power that can be used
simultaneously. Refer to the
installation instructions.
Other fault codes. Defective generator. Contact the service
department.
ERRORS