ETNA EFG409H, Instructions For Use Manual

Page: 24 / 28

24
INSTALLATION
Installation
General
The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
The appliance is not connected to the flue gas
outlet channel.
Electrical connection 230 V - 50 Hz.
■ The electrical connection must comply
with national and local regulations.
■ Wall socket and plug must be accessible at
all times.
Gasconnection: RC 1/2” (ISO 7/1-RC 1/2)
■ The gas connection must comply with
national and local regulations. Amongst
other things these regulations instruct that:
– only approved materials are to be used.
Attention:
The type of gas and the country for which the
appliance has been designed are indicated on
the ratings plate. The appliance is set in the
factory for G25 (natural gas) with a pressure
of 25 mbar. Appliance category I2L.
■ Connect the oven directly to the mains.
This is because the oven can reach high
temperatures. It can also be connected
with a specially designed gas hose. Attach
this hose at the side of the oven to prevent
it touching any hot parts. A gas tap, which
is easily accessible, should always be
used for the appliance.
Built-in dimensions
850
600 (EFG469H)
500 (EFG409H)
600
fig. 5
front view side view
Table burner information (NL II2L3B/P Klasse: 1)
Combustion with G25 low-setting
Rating nominal
Burner position Rear left Rear right Front right Front left Oven
Burner Semi rapid Semi rapid Simmer Rapid Oven burner
Diameter [mm] 94 94 72 125 120
Flow [l/h] 193,8 193,8 110,7 332,2 310,1
Gas type G25/25mbar G25/25mbar G25/25mbar G25/25mbar G25/25mbar
Rating nominal (kW) 1,75 1,75 1,75 1,00 3,00 2,80
Rating minimal (kW) 0,52 0,52 0,52 0,30 0,80 1,40