ETNA CALLISTO, Instructions For Use Manual, Page: 10 / 24

10
© ETNA Coffee Technologies b.v.
Instruction for use CALLISTO
C O F F E E T E C H N O L O G I E S
5.3 Connecting water and electricity
1. Connect a water hose with the correct thread (3/4 inch BSP)
between the connection point on the rear of the machine and the
valve.
2. Open the valve and check that there are no leaks.
3. Plug the mains cable into the connector on the rear of the machine.
4. Plug the other end of the mains cable into an earthed wall socket.
5. Switch the machine on at the on/off switch.
The machine fills with water and heats up. The machine is ready for
use in approximately 15 minutes.
Ꮨ
Never connect more than one unit to one wall socket.
☞
Ensure that the plug will still be accessible once the
machine is in place.
5.4 Loading the BIB or ingredient bag
The liquid concentrate used to prepare drinks can be packaged in two
ways:
•
Bag-In-Box (BIB): in this case the liquid concentrate comes in a bag
contained in a cardboard box. A hose or QCD (Quick Connect
Disconnect) connector may be used with a Bag-in-Box. Paragraph
5.4.1 describes how to load and/or replace a BIB with a hose.
Paragraph 5.4.2 describes how to load and/or replace a BIB with a
QCD connecter. Place the BIB inside the machine on the BIB
support.
• Ingredient bag: in this case the liquid concentrate comes in a bag
which you place in a holder supplied with the machine. Paragraph
5.4.3 describes how to load and/or replace an ingredient bag. The
ingredient bag is loaded in the machine after being placed in the
ingredient bag holder.
Figure 5-1 BIB support