Page 9 of 17
For Support C61-2-9956-7377
Or
ETM8100 Series Quick Start GuideV002
Setting the Baud Rate
The baud rate for the ETM8xxx-xxx can be set in the settings tab of the configuration tool as below.
As default the unit is set to a baud rate of 9600.
The baud rate of the ETM8xxx-xxx modem needs to be set as above with both the
UMTS/GPRS<>Module and MCU<>Port Settings being the same plus the internal engine/module
(TC63i/PHS8-P) must be set to the same baud rate using AT+IPR command. After making setting
changes remember to write to the unit.
Instructions on Setting Module Baud Rate.
1. Change to AT Mode using the ETSC1 command, this can be sent using the drop down box on
the bottom left or by typing into the terminal window
Common ET
commands can be
found and sent from
here
