6
For Support Contact +46 8 25 28 75, [email protected] or +61 2 9956 7377, [email protected]
I.
The device is connected to a CatM1 band. The channel is 20 and the frequency is
800 MHz.
II.
Reference Signal Received Power (the signal strength without noise and interference)
measured in dBm. The signal is visualized in the signal bar below the data. Also
shows Signal Quality (Weak, Low, Medium, High or Strong)
III.
Signal Quality Bar.
IV.
Reference Signal Received Quality (how well the signal is coded) measured in dB.
The signal is visualized in the signal bar below the data.Signal Quality Bar.
V.
Signal Quality Bar
VI.
Signal to Interference plus Noise Ratio (SINR) used to give theoretical upper bounds
on channel capacity (or rate of information transfer)
VII.
Signal Quality Bar
VIII.
Different data rolls in the bottom bar. CH, PLMN, the scanned network and RSSI.
I.
The device is connected to a NB band. The band is 20 and the frequency is 800 MHz.
II.
Reference Signal Received Power (the signal strength without noise and interference)
measured in dBm. The signal is visualized in the signal bar below the data. Also
shows Signal Quality (Weak, Low, Medium, High or Strong)
III.
Signal Quality Bar.
IV.
Reference Signal Received Quality (how well the signal is coded) measured in dB.
The signal is visualized in the signal bar below the data.
V.
Signal Quality Bar.
VI.
Signal to Interference plus Noise Ratio (SINR) used to give theoretical upper bounds
on channel capacity (or rate of information transfer)
CAT-M1 Mode
CAT-NB Mode
Scan Menu CAT-M1 mode
Scan Menu CAT-NB mode
