Turn off the power, connect AC wires. Black wire to L, white wire to N,
and green wire to GND.
Head Offi ce -
1850 Wilson Ave. · Toronto, ON · M9M 1A1 ·
Tel:
416.741.7336 ·
Fax:
416.741.9104
Toll free:
in Canada. 1.800.661.9610 · in USA. 1.888.762.5384 (SOCKETS4U)
www.etlin-daniels.com· For sales/service questions - [email protected]
SAVE THESE INSTRUCTIONS - READ ALL INSTRUCTIONS CAREFULLY
WARNING
WARNING
ATTENTION
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION.
• To prevent personal injury or product damage only licensed electricians/personnel should install fixture.
• To avoid electric shock or component damage disconnect power before attempting installation
or servicing.
• This product must be installed in accordance with the National Electric Code (NEC)/Canadian
Electrical Code (CEC) and all applicable Federal, State/Provincial and Local Electric Codes and
Safety Standards.
• Disconnect fixture and allow cooling prior to servicing.
• Any alteration or modification of this product is expressly forbidden as it may cause serious
personal injury, death, property damage and/or product malfunction.
• To prevent product malfunction and/or electrical shock this product must be properly grounded.
• This Round High bay will operate within the following voltage ranges: 120-347V, 50/60Hz.
• If input voltage exceeds this range, it may cause premature LED diode failure. Please ensure operation is within the
specified voltage ranges.
• Ensure ambient operating temperature between -45°C t45°C.
• Installing the Round High bay in temperatures outside the operating temperature range will reduce the life of the Round High bay.
• Make sure to turn off power during all installation or maintenance processes.
IP65 Wet Location rated.
• Please keep the Round High bay away from all corrosive substances.
• To clean, please use either a damp or dry cloth.
INSTALLATION FOR HBRA7 SERIES ROUND WITH
MICROWAVE SENSOR BASE HIGH BAY
WIRING CONNECTION
HOOK MOUNT
WIRE GUARD
Lock the hook
Tighten the screw.
Hang up the light.
Lock the screw.
REF .1
REF .2
REF .3
REF .4
SCREW HOLE
SCREW
SCREW
driver
1. Take down the 4 screws which show on the picture.
2. Lock the screws according to the picture.
3. Installation complete.
Round High Bay
Wire guard
Plastic spacer
Screw
CAN ICES-005 (B) NMB-005 (B)
