6
Intake Assembly
Intakes and curbs (
) are shipped on a separate skid. Upon unit arrival, perform the following steps
to assemble the intake to the unit.
1. Apply silicone or weather-proof gasket on the backside of the flanges of the intake hood or V-bank
intake.
2. Secure the flanges of the intake hood to the unit with the supplied sheet metal screws.
3. Use caulk on the outside of the screws to prevent water leaks.
4. If the unit is a modular unit with a V-bank or evaporative cooler section, the V-bank or evaporative
cooler will bolt to the heater with the bolts provided.
5. Slide the filters down the filter track.
Figure 2 - Intake and Curb Assembly
1. Unit
2. Intake Housing
3. Intake Filter(s)
4. Curb
5. Mixing Box Curb
1
2
3
4
Direct Fired
1
2
3
5
4
Direct Fired Recirc
Summary of Contents for MUA Controls
Page 82: ...82 Notes ...
Page 83: ...83 CLEANING MAINTENANCE RECORD Date Service Performed ...
