ETIC IPL-3G, User Manual

Page: 34 / 100

SET UP
Page 34
User guide ref 9019409-01 UMTS GPRS EDGE router ref. IPL-3G
2.4 Modifying the configuration from the WAN interface
Coming from the factory, the firewall rejects all the packets coming from the WAN to the LAN.
To modify remotely the configuration, one can use one of the methods described hereafter :
Set a remote user PPTP, TLS, L2TP/IPSec connection towards the antenna iP address of the IPL-3G router.
Connect a PC to the IPL-3G through a
VPN set between the IPL-3G t and another router.
Set up a port forwarding rule to authorise IP frames transmitted to the antenna IP address to be
forwarded to the LAN IP address of the IPL-3G router.
3 Rebooting the router after parameters changes
•
After the parameters of any page have been completed, click the « Save » button at the bottom
of the page.
•
After some parameters changes, the IPL-3G must restart.
When the configuration has been completely carried out, click the « Reboot » red button in the green
bar, when displayed.
•
Once the product has restarted, check the « Reboot » button has disappeared from the green
bar.
T
o save the configuration file to a hard disk :
•
Select the “maintenance” menu and then the “Save / restore” menu.
•
Click the “Save current configuration to disk” button.
4 Recovering the factory LAN IP address
When launching the html browser, the homepage of the html server may not be displayed; the cause
may be the IP address you entered was wrong.
if the IP address you enter is wrong, you can recover the factory IP address by setting SW01 ON
and SW2 OFF but the configuration of the router is not lost.
The factory IP address 192.168.0.128 will be restored as long as the SW01 and SW02 micro switch
will be left in that position.
Remark :
The SW01 and SW02 must not be left in that position during operations.
5 Recovering the factory configuration
If firewall rules have been created finally preventing from reaching any IP address on the LAN
interface including the router itself, it may be necessary to restore the factory configuration of the
router.
To restore the IPL-3G factory configuration,
•
Switch OFF the power supply of IPL-3G router.
•
Press the push button located on the top part of the IPL-3G router under the lid and, switch-on the
power supply.