6
Installation (continued)
DD
AA
EE
A
6
Attaching the housing to the ceiling
□
Drill a 1/8-in. pilot hole into each of the screw locations marked on the ceiling. You can also use an awl or
nail to dimple the screw holes.
□
Install a drywall anchor (DD) and a mounting screw (EE) in each drilled mounting hole, but do not tighten
fully.
□
Align the 2 mounting keyholes on the fixture housing (A) with the 2 mounting screws (EE) in the ceiling.
Once the screw heads are through the large ends of the keyholes, slide the housing (A) until the heads of
the mounting screws (EE) slide into the narrow ends of the keyholes.
□
Finish tightening the mounting screws (EE) until the fixture housing (A) is tightly secured to the mounting
surface.
NOTE:
The drywall anchors
(DD) are only to be used for
mounting the fixture to plaster
or drywall surfaces.
AA
CC
5
Attaching the mounting bracket to the
electrical box
□
Position the wires back inside the electrical box.
□
Mount the mounting bracket (AA) to the electrical box using
the two electrical box screws (CC).
Wire
connectors
Wire
connectors
