background image

3

SAFETY INFORMATION

 

Use this instrument only as specified in this manual, otherwise, the protection 

provided by the instrument may be impaired. 

Please note the warnings and cautions listed below.

WARNINGS

BURN HAZARD- DO NOT

 touch the IR target surface of the unit.

The temperature of the IR target surface is the same as the actual temperature 

shown on the display. If the unit is set at 500 °C and the display reads 500 °C, 

the target surface is 500 °C. The top of the instrument case may exhibit extreme 

temperatures for areas close to the IR target surface.

DO NOT

 turn off the unit at temperatures higher than 50 °C. This could create

a hazardous situation. 

DO NOT

 connect and operate this unit without a properly grounded, properly 

polarized power cord.

HIGH VOLTAGE

 is used in the operation of this equipment. Severe injury or death 

may result if personnel fail to observe safety precautions. Before working inside the 

equipment, turn the power off and disconnect the power cord. Overhead clearance 

is required.

DO NOT

 place this instrument under a cabinet or other structure.

DO NOT

 use this unit in conditions other than those listed in the environmental 

conditions section (page 5).

DO NOT

 operate near flammable materials.

Use of this instrument at 

HIGH TEMPERATURES

 

for extended periods of time 

requires caution. Completely unattended high temperature operation is not 

recommended for safety reasons.

CAUTIONS

To avoid possible damage to the instrument, follow these guidelines.

DO NOT

 plug the unit into 220V if the heater switches and fuse holder read

11OV. This action will cause the fuses to blow and may damage the instrument.

DO NOT

 use fluids to clean the target surface.

DO NOT

 change the values of the calibration constants from the factory set values. 

The correct setting of these parameters is important to the safety and proper 

operation of the calibrator.

Summary of Contents for 822-400













Reviews: