7
Please contact 1-855-384-7754 or further assistance.
Installation (continued)
5
Attaching the housing to the ceiling
□
Drill a 1/8 in. pilot hole into the screw locations marked on the ceiling. You can also use an awl or nail to dimple the screw holes.
□
Install a drywall anchor (EE) and a mounting screw (FF) in each drilled mounting hole, but do not tighten fully.
□
Align the 2 mounting keyholes on the housing (A) with the 2 mounting screws in the ceiling. Once both screw heads are through the
large ends of the keyholes, slide the housing until the heads of the screws slide into the narrow ends of the keyholes.
□
Finish tightening the mounting screws (FF) until the fixture housing (A) is tightly secured to the mounting surface.
NOTE:
The drywall anchors (EE) are only to be used for mounting the fixture onto plaster or drywall surfaces.
FF
GG
A
AA
6
Connecting the dimmer wire to the light dimming wire
□
□
□
www.ETiSSL.com
Connect the anode wire of dimmer to the anode wire
of the dimming driver .
Connect the cathode wire of dimmer to the cathode
wire of the dimming driver .
Fixall of them with single wire connector (CC).
Anode (+)
Cathode (-)
RED
BLUE
Single Wire Connector
Wall Box
Dimmer
To Ballast
