EX29000 Switch Installation Guide
Copyright
©
2014 EtherWAN Systems, Inc.
Page 2
All Rights Reserved
EX29000 rev. 1.0
12/29/2014
6
Front Panel LEDs
LED
Color
Status
System
Green
ON =CPU is coming up.
OFF = CPU is not coming up.
10/100/1000Base-TX Ports
Link/ACT
Green
ON = valid network connection.
OFF = no connection.
Flashing = port is sending or receiving data.
SPEED
Green
ON = valid port connection at 1000 Mbps.
Amber ON = valid port connection at 10 or 100
Mbps.
SFP
Link/ACT
Green
ON = valid SFP link.
OFF = no SFP connection.
Flashing = port is sending or receiving data.
SPEED
Blue
ON = SFP link at 10 Gbps.
Green
ON = SFP link at 1000 Mbps.
7
Managing the Switch
The following procedures are optional, but
recommended for a basic configuration.
A.
Connect a PC to an available switch port
using an appropriate cable.
B.
Confirm that the
Link/ACT
LED for the switch
port to which the PC is connected is ON. If
not, choose a different port.
C.
Configure the PC’s TCP/IP settings to use the
subnet
192.168.1.
X
and subnet mask
255.255.255.0
, where
X
is a number from 2
to 254 other than 10.
D.
In a Web browser address bar, type
E.
Log in to the management interface:
F.
Change the system name:
-
In the left pane, click
+
next to
System
,
then click
System Name/Password
.
-
On the right side, click in the
System
Name
text box.
-
Replace the name shown with a name you
want to assign to the switch.
-
Click the
Update Setting
button below
the
System Name
text box.
G.
By default there is no password assigned to
the switch. To add a password:
-
In the page above, click in the
Password
text box, enter a password, and retype it
in the
Retype Password
text box.
-
Click
Update Setting
below the
Retype Password
text box.
H.
Change the switch’s IP address and subnet
mask to match the scheme on your network: