EtherWAN ER52000, User Manual

Page: 8 / 19

8
ER52000 PoE Switch User Guide
Quick Start Guide
The following procedure enables advanced users to get their Hardened PoE Switch up and running in
the shortest possible time. For detailed installation instructions, refer to the sections in the right column
below.
Step Description For Reference, See…
1. Find a Location for the Hardened PoE Switch
Set the Hardened PoE Switch on a flat surface or Wall-mount.
“Preparing the Site” (page 14)
2. Connect to the 10/100 Mbps Ethernet Port
 Connect one end of a Category 5 or better Ethernet cable to the Ethernet port of a computer,
printer, network storage, or other network device.

Connect the other end to a 10/100 Mbps port on the Hardened PoE Switch.
“10/100 Mbps Ports" (page 11)
and
“Connecting to the 10/100 Mbps Port”
(page 14)
3. Connect to the 10/100/1000 Mbps Ethernet Port

Connect one end of a Category 5 or better Ethernet cable to the Ethernet port of a computer,
printer, network storage, or other network device.

Connect the other end to a 10/100/1000 Mbps port on the Hardened PoE Switch.
“10/100/1000 Mbps Ports" (page 11)
and
“Connecting to the 10/100/1000 Mbps
Port” (page 15)
4. Power On
 Connect the DC power cord to the plug-able M12 S-Coding Male 4-Pin Connector on the PoE
Switch, and then plug it into a standard DC outlet.

Connect the ground connection to the grounding surface.
 Wait for the Hardened PoE Switch to complete its Power On Self Test.
 Confirm that the LEDs for ports connected to a device are on. If not, replace the Ethernet
cable, and then check the port LED again.
“Applying DC Power” (page 15)