10/100Base-TX Hardened Ethernet Extender
2
The Port Status LEDs
LEDs State Indication
Steady Power
on
Power1
Power2
Power3
Off Power
off
Ethernet
Steady Valid network connection established
Flashing
Transmitting or receiving data
ACT stands for ACTIVITY
Link/ACT
Off
Neither valid network connection established nor
transmitting/receiving data
Steady
Connection in full-duplex mode
FDX stands for FULL-DUPLEX
FDX
Off
Connection in h f-duplex mode
al
Ethernet Extender
Remote The device operates in remote mode
Local
The device operates in local mode
Error Error
occurred
Link
A valid connection established
1
Green, 1Mbps, up to 1900M
Amber, 3Mbps, up to 1800M
2
Green, 5Mbps, up to 1600M
Amber, 10Mbps, up to 1400M
3
Green, 15Mbps, up to 1200M
Amber, 20Mbps, up to 1000M
4
Green, 25Mbps, up to 800M
Amber, 30Mbps, up to 700M
5
Green, 40Mbps, up to 600M
Amber, 50Mbps, up o 300M
t
Functional Description
•
Meets NEMA TS1/TS2 Environmental requirements: temperature, shock, and vibration for traffic control equipment.
•
Meets IEC61000-6-2 EMC Generic Standard Immunity for industrial environment.
•
Operates transparent to higher layer protocols such as TCP/IP.
•
Ethernet port: Supports IEEE802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, full/half-duplex; Auto MDI/MDIX.
•
Ethernet Extender port: Symmetrical on the VDSL, full-duplex 50Mbps communications link over existing copper telephone line.
•
One DIP switch for configuring Local (Loc) and Remote (Rmt).
•
Ten speeds with speed indicator LEDs on front panel of unit, up to 50Mbps @ about 300meters (984ft.), down to 1Mbps @ about
1,900meters (6,233ft.).
•
Operating voltage and Max. current consumption: 0.35A @ 12VDC, 0.175A @ 24VDC. Power consumption: 4.2W Max.
•
Power Supply: Redundant 12-30VDC Terminal Block power inputs and 12VDC DC JACK with 100-240VAC external power supply. “For
use with Model UP0351E-12P as power jack supply source by Universal Micro Electronics Co., Ltd.".
•
Field Wiring Terminal: Use Copper Conductors Only, 14-24 AWG torque value 4.5 lb-in.
•
Operating temperature range @ -40 to 75 (
℃
℃
-40
℉
to 167
℉
). Tested for functional operation @ -40 to
℃
85 (
℃
-40
℉
to 185
℉
). UL508
Industrial Control Equipment certified Operating Surrounding Air Temperature @ -34
℃
to 60
℃
(-29
℉
to 140
℉
).
•
Supports Din-Rail or Panel Mounting installation.
Assembly, Startup, and Dismantling
•
Assembly: Place the Hardened Ethernet Extender on the DIN rail from above using the slot. Push the front of the Hardened Ethernet
Extender toward the mounting surface until it audibly snaps into place.
•
Startup: Connect the supply voltage to start up the Hardened Ethernet Extender via the terminal block (or DC JACK).
•
Dismantling: Pull out the lower edge and then remove the Hardened Ethernet Extender from the DIN rail.