12
Federal Communication Commission Interference
Statement - Part 15
This device complies with Part 15 of the FCC Rules. Ope「at1on 1s
sub」ect to the following two conditions
1. This device may not cause harmful interference, and
2. This device must accept any inte「ference received, including
inte「ference that may cause undesired ope「ation
NOTE: This equipment has been tested and found to comply with
the limits fo「 a Class B digital device, pursuant to Pa「t 15of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interfe「ence in a residential installation. This
equipment generates, uses and can radiate 「adio f「equency energy
and, if not installed and used in accordance with the instructions,
may cause harmful inte「fe「ence to radio communications. Howeve「,
there is no guarantee that interfe「ence will not occur in a particula「
installation. If this equipment does cause harmful interference to
「adio o「 television reception, which can be determined by turning the
equipment off and on, the use「 is encou「aged to try to correct the
interference by one or more of the following measures
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a ci「cuit diffe「ent
f「om that to which the receive「 is connected
Consult the dealer or an experienced radio/TV techn,c,an
fo「 help
FCC Caution: Any changes or mod币cations not expressly app「oved
by the pa「ty 「esponsible fo「 compliance could void the use「·s
authority to operate this equipment
FCC Radiation Exposure Statement
This equipment complies with FCC 「ad1ation exposu「e limits set forth
for an uncontrolled envi「onment. End users must follow
the specific operating instructions for satisfying RF exposu「e
compliance. To maintain compliance with FCC RF exposure
compliance requirements, please follow ope「ation instructions as
documented in this manual. This transmitter must not be co-located
0「 ope「at1ng in con丿unction with any other antenna o「 t「ansmitter The
availab小ty of some spec币c channels and/or ope「ational frequency
bands are country dependent and are什rmware
P「ogrammed at the factory to match the intended destination. The
什rmware setting is not accessible by the end use「
The device has been evaluated to meet general
RF
exposure
requirement. The device can be u sed in portable exposure condition
without restriction
FCC SDOC SUPPLIER'S DECLARATION OF CONFORMITY
ETEKCITY CORPORATION he「eby declares that this equipment 1s 1n
compliance with the FCC Part 15 Subpart B
The decla「at,on of confo「mity may be consulted ,n the support
section of ou「Web site, accessible f「om www.etekcity.com
Attributions
The Bluetooth• word mark and logos are 「egistered t「ademarks
owned by Bluetooth SIG, Inc and any use of such marks by Etekcity
Corporation 1s under license. Other trademarks and trade names are
those of their 「espective owne「S
