LifeWorkEtc.com
800-634-9514
STEP
01
VORA
ASSEMBLY
PLACE SEAT ASSEMBLY UPSIDE DOWN ON AN
ELEVATED FLAT SURFACE. POSITION SWIVEL TILT
CONTROL MECHANISM ON BOTTOM SIDE OF
SEAT ASSEMBLY TO MATCH THE INSIDE 4-HOLE
CONFIGURATION.
NOTE: THE SWIVEL TILT CONTROL ADJUSTMENT
KNOB IS TO BE POSITIONED TOWARD THE FRONT OF
THE SEAT. THE FRONT OF THE SEAT IS IDENTIFIED
BY THE FRONT ASSET LABEL. USING THE 5MM HEX
KEY WRENCH, SECURE THE SWIVEL TILT CONTROL
MECHANISM TO THE SEAT ASSEMBLY USING FOUR
5/16-18 X 1" HEX HEAD BOLTS.
FRONT
OF SEAT
STEP
02
POSITION THE RIGHT AND LEFT ARM ASSEMBLIES
ON THE BOTTOM OF THE SEAT AS SHOWN.
NOTE: TO ASSURE PROPER ASSEMBLY OF THE
RIGHT AND LEFT ARMS, EACH ARM SHOULD ANGLE
TOWARD THE FRONT OF THE SEAT, NOT REARWARD.
USING THE 5MM HEX KEY WRENCH, SECURE EACH
ARM WITH THREE 5/16-18 X 1 1/4" TRUSS HEAD BOLTS.
FRONT
OF SEAT
