background image

ETC Installation Guide

Contact and Demand Response Interfaces

Corporate Headquarters 

 Middleton, Wisconsin, USA 

 Tel +608 831 4116 

Service (Americas) 

 

s[email protected]

 

London, UK 

 Tel +44 (0)20 8896 1000 

 Service: (UK)

 

[email protected] 

Rome, IT 

 Tel +39 (06) 32 111 683 



Service: (UK)

 

[email protected] 

Holzkirchen, DE 

 Tel +49 (80 24) 47 00-0 

 Service: (DE)

 

[email protected] 

Hong Kong 

 Tel +852 2799 1220 

 Service: (Asia)

 [email protected]

Web:

 

etcconnect.com

 

 © 2018 Electronic Theatre Controls, Inc. 

 Product information and 

specifications subject to change. 

 ETC intends this document to be provided in its entirety.

7186M2144 

 Rev B 

 Released 2018-04 

Overview

The Unison Echo

®

 Contact and Demand Response Interfaces are DIN rail 

mounted devices that are available in the following configurations:

• Input Interface - accepts four momentary or maintained closures to 

trigger control actions within an Echo control system.

• Demand Response Interface - accepts four maintained closures to 

trigger demand response within an Echo control system.

• Output Interface - provides four normally open or normally closed 

output relays controlled by actions in the Echo control system.

Custom Configuration

This document guides you through the installation and basic local 
configuration settings of the interface devices.

For more detailed information about custom configuration options available 
using EchoAccess

®

, reference the EchoAccess Mobile App integrated help 

system.

Accessory Kit

ETC offers a Low Voltage DIN rail Cover Kit (ETC part number 7186A1218) 
that allows installation of a Contact Interface to a 4” (10 cm) junction box 
(provided by others). Contact ETC for ordering details.

Note: To use the configuration settings applied using 

EchoAccess, the unit must be placed in Custom 

configuration mode. Reference 

Set Configuration Mode

.

Contact Input Interface

Demand Response Interface Contact Output Interface

Summary of Contents for Unison Echo









Reviews: